Fog lights, checking aim and adjusting

Checking and adjusting requirements. See HEADLIGHTS, AIMING USING HELLA UNIVERSAL BEAMSETTER IV .

• Switch ignition on.
• Switch fog lamps on.

• Vehicle must stand at distance x = 10 m (32.8 ft), on flat surface, in front of vertical wall Y
Fig 1: Checking Vehicle Parking Distance
Courtesy of AUDI OF AMERICA, INC.

For correct foglight adjustment, the light must project on the vertical wall -Y- as follows:

Shaded surface: light beam of fog lamp

b - Height of optical axis (focal point) of fog lamp

a - Adjustment dimension = 200 mm (7.87in.) below center point -b-

Fig 2: Checking Fog Light Adjustment Dimension

Courtesy of AUDI OF AMERICA, INC.

• Remove cover in lower part of bumper by pulling out toward front (arrow).
Fig 3: Removing Cover In Lower Part Of Bumper
Courtesy of AUDI OF AMERICA, INC.
• To lower light beam, turn adjustment screw (arrow) to left (lateral adjustment is not possible).
Fig 4: Locating Fog Light Adjustment Screw
Courtesy of AUDI OF AMERICA, INC.