Step 3: Adapting throttle valve control module to engine control module: Condition

WARNING: This page is about a different car, the 2003 Audi RS 6. However, it is still accessible from the selected car via links, so may be relevant.

Engine stopped, ignition on

Indicated on VAS 5051:

Fig 1: Function Display VAS 5051 - Generating Readiness Code, Adapting Throttle Valve Control Module To Engine Control Module (1 Of 3)

Courtesy of AUDI OF AMERICA, INC.

From list -1- select diagnostic function "04 - Basic setting".

Indicated on VAS 5051:

Fig 2: Function Display VAS 5051 - Generating Readiness Code, Adapting Throttle Valve Control Module To Engine Control Module (2 Of 3)

Courtesy of AUDI OF AMERICA, INC.

- Enter display group

Use keypad -2- to enter "060" for "Display group number 060" and confirm by touching Q key.

Indicated on VAS 5051:

Fig 3: Function Display VAS 5051 - Generating Readiness Code, Adapting Throttle Valve Control Module To Engine Control Module (3 Of 3)

Courtesy of AUDI OF AMERICA, INC.

Activate basic setting by touching key -A-.
Check display in zones -3- and -4-.

DISPLAY GROUP 060: ADAPTATION OF THROTTLE VALVE CONTROL MODULE

	Display zones
	1	2	3	4
Display group 060: Adaptation of throttle valve control module
Display	xx %	xx %	x	-
Significance	Throttle valve angle (angle sender 1)	Throttle valve angle (angle sender 2)	Adaptation step counter	Adaptation status
Operating range			0...8	ADP in progress ADP OK ERROR
Spec.	3...93 %	97...3 %	8	ADP OK
Note			Adaptation step counter is set to 8 on completion of adaptation (values may be skipped)	If "ERROR" is displayed: Interrogate fault memory, see FAULT MEMORY, INTERROGATING AND ERASING If reading does not match specification: see , ANGLE SENSOR 1 FOR THROTTLE DRIVE -G187- AND ANGLE SENSOR 2 FOR THROTTLE DRIVE -G188-, CHECKING .

Note on display zone 3:

During adaptation, various values appear in display zone 3 as an indication of the corresponding adaptation status. The behavior of the adaptation step counter (display zone 3) during adaptation is not the decisive factor, but rather that the specification "ADP OK" appears in display zone 4 on completion of adaptation.

If specification "ADP OK" is obtained:

Touch > key.
Proceed with next step.