Final control diagnosis: Notes
WARNING: This page is about a different car, the 2003 Audi RS 6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Final control diagnosis can only be performed with the engine stopped and the ignition switched on.
- During final control diagnosis the individual control elements (except injectors) are actuated for approx. 1 minute or until--> key is pressed to select next control element.
- The control elements are checked acoustically or by means of touch.
- Final control diagnosis is terminated if the next step is not selected after an actuation time of approximately 1 minute, or if the engine is started or an engine speed pulse is detected.
- Prior to restarting the final control diagnosis, the engine must be started and the ignition switched off and on again.