Adaptation after replacing instrument cluster and the Engine Control Module (ECM): Procedure:

• Input VIN in instrument cluster (only possible with VAS 5051 tester).
• Perform adaptation after replacing Engine Control Module (ECM). See ADAPTATION AFTER REPLACING ENGINE CONTROL MODULE (ECM)  .
• Perform adaptation of vehicle keys. See ADAPTATION OF VEHICLE KEYS  .

Display on VAS 5051:

Fig 1: Display On VAS 5051 - Adaptation After Replacing Instrument Cluster And Engine Control Module (1 Of 3)

Courtesy of AUDI OF AMERICA, INC.

• Press selection -1- of vehicle system "17 - instrument cluster"
• Wait until the next indication appears on display.

Display on VAS 5051:

Fig 2: Display On VAS 5051 - Adaptation After Replacing Instrument Cluster And Engine Control Module (2 Of 3)

Courtesy of AUDI OF AMERICA, INC.

1. Control module identification of the instrument cluster
2. Control module identification of immobilizer

• Click on --> button

Display on VAS 5051:

Fig 3: Display On VAS 5051 - Adaptation After Replacing Instrument Cluster And Engine Control Module (3 Of 3)

Courtesy of AUDI OF AMERICA, INC.

• Select diagnostic function "transfer VIN" in selection -1-.
• Enter the vehicle's VIN and confirm.
• Perform "Adaptation after replacing Engine Control Module (ECM)". See ADAPTATION AFTER REPLACING ENGINE CONTROL MODULE (ECM)  .
• Adapt all vehicle keys. See ADAPTATION OF VEHICLE KEYS  .

Instrument cluster, Engine Control Module (ECM) and vehicle keys are now adapted and the vehicle can be started.