Scan tool functions, selecting: Notes

After establishing diagnostic communication, checking the control module version and pressing --> button, proceed as follows:

Indicated on display:

Fig 1: VAG 1551/3 Scan Tool Display - Select Function XX

Courtesy of AUDI OF AMERICA, INC.

1. (Function selection, for example, 02 - Check DTC Memory)

You can now select one of the functions listed below. Start the troubleshooting routine with function 02 "Check DTC Memory".

1. Check Control Module Versions
2. Check DTC Memory
3. Output Diagnostic Test Mode
4. Basic Setting
5. Erase DTC memory
6. End Output
7. Code Control Module
8. Read Measuring Value Block
9. Read Individual Measuring Value
10. Adaptation
11. Login procedure

The functions "Erase DTC memory" and "End Output" are described below.

The other functions listed here are described in the relevant sections.

When a function has been performed and completed, Press --> button in order to return to the start position of the troubleshooting routine: "Select function".