Read measuring value block: display group 3

NOTE:

The On Board Diagnostic (OBD) is terminated by ABS control module (w/EDL) -J104- if road speed exceeds 19 km/h.
If the Torque reduction value is subtracted from the Engine torque value, the result is Engine torque - actual (referred to as MMI)

Fig 1: Read Measuring Value Block Chart (Display Group 3)

Courtesy of AUDI OF AMERICA, INC.

For DTC table, see ESP DIAGNOSTIC TROUBLE CODE (DTC) MEMORY, CHECKING .

NOTE: The display group numbers can be selected in sequence by pressing buttons -1- and -3- ((VAG 1551 scan tool) or buttons uparrow and downarrow ((VAG 1552 scan tool) or by pressing" uparrow "and" downarrow" on the screen of VAS 5051 vehicle diagnostic, testing and information system.

Press button -C- in order to enter the display group number manually.

Indicated on display

Fig 2: VAG 1551 Scan Tool Display - Enter Display Group Number XXX

Courtesy of AUDI OF AMERICA, INC.

Press buttons -0-, -0- and -4-.
Press -Q- button to confirm input.

NOTE: For Read measuring value block: display group 4

On control modules with Part No. 4D0 907 389 (without index letter), display group No. 4 is vacant, and cannot be selected by pressing buttons -1- and -3- on VAG 1551 scan tool or buttons uparrow and downarrow on VAG 1552 scan tool.
If you try to select Display Group No. 4, the display will show:

Indicated on display

Fig 3: VAG 1551 Scan Tool Display - Function Unknown Or Not Carried Out At Moment

Courtesy of AUDI OF AMERICA, INC.

Press --> button.

Fig 4: VAG 1551 Scan Tool Display - Select Function XX

Courtesy of AUDI OF AMERICA, INC.

Indicated on display

If you do not wish to exit from the function "Read Measuring Value Block" you must avoid selecting Display Group No. 4: press button -C- and select Display Group No. 3 or 5 directly by entering the respective number.