LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2001 >> S4 Quattro, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Programming >> Setting Speed Warning Limit >> Speed Warning No. 2

Speed Warning No. 2

NOTE: With ignition switch off, desired speed warning limit can be set so that speed warning limit cannot be changed while driving vehicle. Speed warning limit No. 1 will operate normally.
  1. Briefly press dimmer switch adjustment knob. See Figure . Mileage recorder will be displayed. Press dimmer switch adjustment knob for longer than 2 seconds. Current set speed warning limit will be displayed.
  2. To change speed warning limit, press top or bottom of trip computer button, located on end of wiper/washer stalk. Press button up to increase set speed or down to decrease set speed. If buttons are not pressed within a few seconds, vehicle will saved last displayed setting. If desired setting is not achieved, go to step  1 . If desired speed warning limit is achieved, go to next step.
  3. To cancel set speed warning limit, turn ignition off. Briefly press dimmer switch adjustment knob. Display will light up. Press dimmer switch adjustment knob for longer than 2 seconds. Current set speed warning limit will be displayed. Press and trip reset switch until current setting is replaced with a crossed out warning symbol.
scientia non olet · About LEMON Manuals