Possible Causes & Corrective Action

Open or short in Gray/Yellow wire between terminal No. 9 of radio harness connector and terminal No. 15 of instrument cluster Blue 32-pin harness connector. See Figure . Repair wiring. See WIRING DIAGRAMS  .

Control module incorrect (does not support CAN). Replace control module. Control module that supports CAN is not indicated with a 1 in measured value block display group 140. See FUNCTION MODE 08: READING MEASURED VALUE BLOCK  under SELF-DIAGNOSTIC SYSTEM.

Adaptation for instrument cluster was not performed properly. Input correct adaptation number in channel 62. See FUNCTION MODE 10: ADAPTATION  under SELF-DIAGNOSTIC SYSTEM.