Removing steering column switch

Drivers airbag unit and steering wheel removed

• Pull out steering column and tilt downward as far as it will go.

Fig 1: Grip And Screws

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove screws - 1  - (2x), tightening torque 2.8 Nm.
• Remove grip - 2  -.

Fig 2: Upper Steering Column Switch Trim And Screws

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove two Phillips-head screws - arrows  -.
• Tightening torque 0.6 Nm
• Remove upper steering column switch trim - 1  -.

When installing, insert upper section into hooks on lower section, swivel downward and secure with screws.

Fig 3: Lower Steering Column Switch Trim And Screws

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove screws - 2  - (2x). Tightening torque 0.6 Nm
• Remove hex socket head bolt - 1  -.
• Tightening torque 0.6 Nm
• Remove lower steering column switch trim - 3  -.

Fig 4: Connection And Locking Tabs

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Separate connection - 1  -.
• Release locking tabs - arrows  - and pull coil connector with slip ring off steering column switch.

• Remove screw - 2  -.
• Tightening torque 2.8 Nm
• Disconnect harness connectors - 3  - (2x).
• Remove steering column switch - 4  -.