Instrument panel, removing: Installing
- Extend photo sensor wire by attaching a cord or cable tie.
- Extend loudspeaker wire by attaching a cord or cable tie.
- Locate instrument panel and insert extensions attached to photo sensor and loudspeaker wires.
- Clip - 1 - together with felt pad - 2 -
- Insert instrument panel into clips - 1 - , at the same time pressing it down slightly.
- Press gently to check that instrument panel is installed properly in clips - 1 -.
- Install steering column switch but do not tighten mountings.
- Install lower section of trim - 3 - for steering column switch.
- Tighten screws - 2 - (2x).
- Tightening torque 0.6 Nm
- Install screw - 1 - , but do not tighten.
- Install self-cancelling ring with coil connector and slip ring.
- Install steering wheel.
Fig 3: Steering Column Switch With Lower Section Of Trim Measurement, Clamp And Hex Socket-Head Bolt
- Position steering column switch with lower section of trim at a distance of 3 mm from steering wheel (distance - a - ).
- Tighten clamp - 1 -.
- Tightening torque 2.8 Nm
- Tighten hex socket-head bolt - 2 -.
- Tightening torque 0.6 Nm
- Perform remaining installation steps in reverse order of removal.