Lateral acceleration sensor, removing and installing

NOTE:

• A lateral acceleration sensor is installed under each of the front seats.
• The two sensors are identical (arrow faces outward on installation).
• Removing: 

• Disconnect battery Ground (GND) strap.
• Remove front seat → Seat, removing and installing .
• Remove lower - A  - pillar trim → Removing and installing lower A-pillar trim .
• Unclip sill panel trim on inside.

• Lift carpeting around sensor.
• Cut through cable tie - 4  -.
• Unplug connector - 2  - for lateral acceleration sensor - 1  -.

Fig 1: Lateral Acceleration Sensor, Screws, Cable Tie And Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove screws - 3  - (2x). Tightening torque 6 Nm
• Remove lateral acceleration sensor - 1  -.

• Installing: 

• Replace cable tie.
• Switch ignition on.

CAUTION: Make sure no-one is in the vehicle when connecting battery.

• Close doors.
• Connect battery Ground (GND) strap.

NOTE:

• After connecting the battery, check vehicle equipment (radio, clock, electric windows) → 91 RADIO, TELEPHONE, NAVIGATION, TRIP COMPUTER or Owners Manual.
• If the Airbag Malfunction Indicator Lamp (MIL) K75 signals a malfunction after assembling, then DTC memory must be erased and checked again using vehicle diagnostic, testing and information system VAS 5051 A scan tool.