Glove box locking mechanism, removing and installing

Fig 1: Glove Box Cover And Screws

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove screws - 1  - (6x), tightening torque 1 Nm.
• Pull out cover - 2  - in direction of - arrow  -.

Fig 2: Glove Box Locking Mechanism Remove/Install Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Use screwdriver to pry out linkage - 1  - (2x) at guides - 2  -.
• Pull linkages - 1  - (2x) inwards at - 3  -.
• When installing, insert linkages - 1  - (2x) at gear wheel so that projection at - 3  - is approx. 5 mm.