Tightening torques
NOTE:
- The tightening torques listed on this article apply only to lightly greased, oiled, anodized, or black-finished nuts and bolts.
- Additional lubricant such as engine and transmission oil may be used, but do not use molybdenum lubricant.
- Do not use degreased parts.
- Tolerance for tightening torques is ± 15%.
- Tightening torque for screw clamps: 2 Nm
Engine/transmission mounts (manual transmission)
A: centering sleeves
| Item No. | Bolt | Nm |
| 1 | M12 x 55 | 65 |
| 2 | M12 x 55 1) | 65 |
| 3 | M12 x 140 1) | 65 |
| 4 | M12 x 140 1) | 65 |
| 5 | M10 x 50 | 45 |
| 6 | M10 x 70 | 45 |
| 7 | M10 x 50 | 45 |
| 8 | M12 x 55 | 65 |
1) Bolt with M8 stud
| Components | Nm | |
| Bolts/nuts | M6 | 10 |
| M8 | 20 | |
| M10 | 45 | |
| M12 | 65 | |
| Except for the following: | ||
| Drive axles to transmission | M8 | 40 |
| Engine support to engine console | 85 | |
| Transmission support to transmission console 1) | 60 + 90° | |
| Drive plate to | ||
| Torque converter | M10 x1 | 85 |
| Pendulum support to transmission 1) | 40 + 90° 2) | |
| Pendulum support to subframe1) | 20 + 90° 2) | |
| Front exhaust pipe to turbocharger | 40 | |
| A/C compressor to bracket | 45 | |
| Drive axle heat shield to cylinder block | 35 | |
| Nuts for clamp | 40 | |
1) stretch bolts - replace
2) 90° is a quarter turn