Radiator, removing and installing: Installing
Installation is carried out in the reverse order, when doing this note the following:
- Install mounts -3- and -4- on radiator as illustrated.
- Install radiator securing bolts (the help of a 2nd mechanic is required).
- Install front bumper:
Refer to 63 BUMPERS ; Front bumper, removing and installing
- Replace O rings in the coolant hose connections.
- Fill up with coolant. Refer to Filling .
- After connecting battery terminals, enter anti-theft code for radio
Refer to Radio operating instructions
- Close electric windows in front doors all the way to their top positions using electric switches.
- Then operate all electric window switches again for at least one second in the "close" direction to activate the automatic one-touch function.
- Set clock to correct time.
- Interrogate DTC memory:
Refer to
- 01 ON BOARD DIAGNOSTIC (OBD) for 1.8 LITER 4-CYL. 5V TURBO FUEL INJECTION & IGNITION, ENGINE CODE(S): AMU
- 01 ON BOARD DIAGNOSTIC (OBD) for 1.8 LITER 4-CYL. 5V TURBO FUEL INJECTION & IGNITION, ENGINE CODE(S): ATC
- 01 ON BOARD DIAGNOSTIC (OBD) for 1.8 LITER 4-CYL. 5V TURBO FUEL INJECTION & IGNITION, ENGINE CODE(S): AWP
- 01 ON BOARD DIAGNOSTIC (OBD) for 1.8 LITER 4-CYL. 5V TURBO FUEL INJECTION & IGNITION, ENGINE CODE(S): BEA
NOTE:
DTC will have been stored in the memory because connectors have been disconnected. Therefore interrogate and erase DTC memory after installing engine.
Tightening torques
| Components | Nm |
| Radiator fan cowl to radiator | 10 |
| Thermal switch to radiator | 35 |
| Radiator to lock carrier | 10 |
| Condenser to radiator | 10 |
| Control unit to longitudinal member | 10 |