Dual mass flywheel, removing and installing

Removing 

• Mark installing position of dual mass flywheel on crankshaft with a permanent felt-marker.

Fig 1: Inserting Retainer 3067 In Hole On Cylinder Block

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Insert counter-hold tool 3067 in drilling in cylinder block, and engage on flywheel.

• Insertion position for counter-hold tool:

A - To tighten

B - To loosen

• Loosen flywheel bolts.

Installing 

• Install dual mass flywheel to crankshaft in the position marked when removing it.
• Install new bolts and tighten.

Tightening torque 

1) 90° = 1/4 turn