Drive plate, removing and installing
Removing
- Secure counter-hold tool VW 558 to the drive plate with a hexagon bolt M8x45. Place two M10 hexagon nuts -1- between counter-hold tool and drive plate.
- Loosen securing bolts on drive plate.
Installing
- Install drive plate using packing plate with notches -1-.
- Insert at least 3 of the old securing bolts -3- and tighten to 30 Nm.
Fig 3: Checking Installation Position Of Drive Plate By Measuring At Three Points And Calculate Average
- Check installation position of drive plate by measuring at three points and calculate average.
- Specification: 19.5-21.1 mm
NOTE:
Measurement is taken through the hole in the drive plate to the machined surface of the cylinder block.
- If the distance is too large:
- Remove drive plate again and install appropriate shim -2-.
- Measure distance again.
- If specification is achieved:
- Install new bolts and tighten.
Tightening torque
| Component | Nm | |
| Drive plate to crankshaft | 60 + 90° 1) | |
1) 90° = 1/4 turn