Window lifter switches, removing and installing
CAUTION:
Before beginning repairs on the electrical system:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
Removing
NOTE:
Driver's window lifter switch illustrated. Procedure is the same for all switches.
- Remove applicable door panel
Refer to 70 - INTERIOR TRIM
- Disconnect electrical connections -1- and -2-.
- Pull guide sleeve -3- out of door trim.
- Use small screwdriver to carefully release fasteners -arrows-.
- Remove switch -3- from door panel -arrow-.
Installing
Install in reverse order of removal of removal.