Ignition/starter switch, removing and installing

Removing 

• Remove steering column switches. Refer to Steering column switches, removing and installing  .

Fig 1: Locating Screws , Ignition/Starter Switch And Steering Lock Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Disconnect electrical connection -1- at ignition/starter switch.
• Remove locking fluid from screws -arrows-.
• Loosen screws -arrows- slightly and pull ignition/starter switch out of steering lock housing -2-.

Installing 

Install in reverse order of removal, noting the following:

Fig 2: Locating Screws , Ignition/Starter Switch And Steering Lock Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Apply locking fluid to lock housing screws -2-.