Turn signal bulb, replacing

CAUTION:

Before beginning repairs on the electrical system:

Obtain the anti-theft radio security code.
Switch off all electrical consumers.
Switch ignition off and remove ignition key.
Disconnect negative ( - ) battery terminal.

When reconnecting battery terminals, observe all applicable Notes and torque specifications, as well as instructions on performing OBD program and electrical system function checks as specified in this article. Refer to Battery, disconnecting and reconnecting .

WARNING:

HIGH VOLTAGE!
Always disconnect negative ( - ) battery terminal prior to servicing any parts of the HID lamp system marked with the yellow "HIGH VOLTAGE!"symbol.
After disconnecting battery, briefly turn headlights on and off in order discharge any residual voltage.

Removing

Disconnect battery. Refer to Battery, disconnecting and reconnecting .

Left headlight:

Fig 1: Removing Cover Above Battery

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove cover -arrows-.
Remove battery if necessary. Refer to Battery, removing and installing .

Right headlight:

Fig 2: Removing Screw And Coolant Expansion Tank Cover

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove screw -1- and remove cover over expansion tank -arrow-.

Both sides (continued):

Fig 3: Turning Holder Counter-Clockwise

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Turn holder -1- counter-clockwise -arrow- and remove from housing.
Twist and remove bulb from holder.

Installing

Install in reverse order of removal, noting the following:

CAUTION:

Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that evaporates on the bulb during operation can cause the glass to cloud over.

Insert new bulb in holder.
Reinstall battery if necessary.
Reconnect battery. Refer to Battery, disconnecting and reconnecting .