LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2000 >> TT Base, 1.8 C >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panels >> Self-Diagnostic System >> Function Mode 10: Adaptation >> Channel 09

Channel 09

NOTE: This function is used to adapt odometer after instrument cluster is replaced. Changing odometer reading can only be done on an instrument cluster once. If incorrect value is entered and confirmed, instrument cluster must be replaced. Odometer cannot have more than 100 kilometers on it (new instrument cluster). The value entered must be in kilometers. To convert miles to kilometers, multiply miles by 1.609. Only adaptation values greater than 100 kilometers can be entered.
  1. When RAPID DATA TRANSFER SELECT FUNCTION XX is displayed, press 1 key twice (11). RAPID DATA TRANSFER 11-LOGIN PROCEDURE will be displayed. Press "Q" key to confirm input. LOGIN PROCEDURE ENTER CODE NUMBER XXXXX will be displayed. Enter code number 13861. LOGIN PROCEDURE ENTER CODE NUMBER 13861 will be displayed. Press "Q" key to confirm input.
  2. RAPID DATA TRANSFER SELECT FUNCTION XX will be displayed. Press 1 and 0 keys. RAPID DATA TRANSFER 10 - ADAPTATION will be displayed. Press "Q" key to confirm input. ADAPTATION FEED IN CHANNEL NUMBER XX will be displayed.
  3. Press 0 and 9 keys (09), then press "Q" key to confirm input. CHANNEL 9 ADAPTATION 0 <-1 3-> will be displayed. Press right arrow key.
  4. CHANNEL 9 ADAPTATION 0 INPUT ADAPTATION VALUE XXXXX will be displayed. Enter desired odometer reading to the nearest 10 kilometers. For example, if 89627 kilometers is desired, enter 08963 (first number represents 100,000 kilometers, second number represents 10,000 kilometers, third number represents 1,000 kilometers, fourth number represents 100 kilometers and fifth number represents 10 kilometers). CHANNEL 9 ADAPTATION 0 ENTER ADAPTATION VALUE 08963 will be displayed.
    CAUTION: Ensure correct value has been entered before confirming it, because this value can NEVER be changed again.
  5. Press "Q" key to confirm input. CHANNEL 9 ADAPTATION 8963 <-1 3-> will be displayed. Press "Q" to confirm input. CHANNEL 9 ADAPTATION 8963 STORE CHANGED VALUE? will be displayed.
  6. Press "Q" to confirm input. CHANNEL 9 ADAPTATION 8963 CHANGED VALUE IS STORED will be displayed. Press right arrow key to complete adaptation of odometer.
scientia non olet · About LEMON Manuals