Fuel level sender, adaptation
This function is used to adjust the resistance range of the fuel level sender signal to compensate for any discrepancies in the "empty" and "full" values.
| Rapid data transfer HELP Select function XX |
Indicated on display:
- Press buttons -1- and -0- and confirm input with Q button.
| Adaptation Enter channel number XX |
Indicated on display:
- Press buttons -3- and -0- to access "channel 30"
- Press -Q- button to confirm input
| Channel 30 Adaptation 128 → < - 1 3- > |
Indicated on display (example only): the display will show the adaptation value, e.g. 128.
NOTE:
- The adaptation value displayed represents the standard resistance range for the fuel gauge sender as set by the factory (default value = 128).
- The adaptation value for the fuel gauge sender resistance range can be adjusted from the pre-set value by ± 8 (range = 120... 136).
- If default value value "128" has been changed due to customer complaint of inaccurate fuel level readings, the changed value must also be applied to the replacement instrument cluster.
- Press " button.
| Channel 30 Adaptation 128 Enter adaptation value XXXXX |
Indicated on display:
- Enter adaptation value (e.g. 132) via button pad on scan tool, filling in the initial spaces with "0."
| Channel 30 Adaptation 128 Q Enter adaptation value 00132 |
Indicated on display (example only):
- Press -Q- button to confirm input
| Channel 30 Adaptation 132 Q < - 1 3- > |
Indicated on display:
- Press -Q- button to confirm input
| Channel 30 Adaptation 132 Q Store changed value? |
Indicated on display:
- Press -Q- button to confirm input
| Channel 30 Adaptation 132 → Changed value is stored |
Indicated on display:
- Press → to terminate adaptation of fuel gauge sender resistance range.