LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2000 >> TT Base, 1.8 C >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Electrical Equipment - General Information >> 96 - Lights, Switches - Interior, Anti-theft >> Trailer Hitch Wiring Socket >> Trailer Hitch Wiring Socket, Removing and Installing >> Trailer Hitch Wiring Socket, Removing and Installing

Trailer Hitch Wiring Socket, Removing and Installing

Fig 1: Trailer Hitch Wiring Socket Remove/Install Components
GW00017200Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing 

CAUTION:
  • Switch off ignition.
  • Switch off all electrical consumers and remove ignition key
Fig 2: Switch Connector And Connector At Socket
GW00017201Courtesy of VOLKSWAGEN UNITED STATES, INC.

Wiring socket with Switchable Rear Fog Lamp Shut-Off Contact Switch F216 :

Fig 3: Pressing Multi-Pin Connector Out Of Socket
GW00017202Courtesy of VOLKSWAGEN UNITED STATES, INC.

Wiring socket without Switchable Rear Fog Lamp Shut-Off Contact Switch F216 :

Fig 4: Releasing Securing Tabs And Then Releasing Retainer Clips
GW00017203Courtesy of VOLKSWAGEN UNITED STATES, INC.

Version 1:

Fig 5: Releasing Securing Tabs And Then Retaining Clips
GW00017204Courtesy of VOLKSWAGEN UNITED STATES, INC.

Version 2:

Fig 6: O-Rings, Harness Connectors And Retainer
GW00017205Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installing 

Install in reverse order of removal, noting the following:

NOTE:
  • Ensure O-rings - 1  - and - 3  - are not damaged.
scientia non olet · About LEMON Manuals