Pay particular attention to the following on installation:

• In engine compartment clean areas contaminated with fluid.
• Before installing new power steering pump, pour in hydraulic fluid on intake end and crank by hand until fluid emerges on discharge end.
• Replace O-ring on drive shaft of power steering pump.
• Replace oil seals.
• Secure all hose connections with standard hose clamps.

See Parts Catalog

• Install engine bracket and screw on subframe (see SUBFRAME & SUBFRAME BUSHINGS ).
• Install stabilizer bar (STABILIZER BAR & BUSHINGS ).
• Install drive axle. See AXLE SHAFTS - FRONT & REAR .
• Check hydraulic fluid level. See POWER STEERING FLUID LEVEL, CHECKING; STEERING SYSTEM, BLEEDING AND CHECKING FOR LEAKS .
• Bleed power steering system. See STEERING SYSTEM, BLEEDING .
• Check power steering system for leaks. See STEERING SYSTEM, CHECKING FOR LEAKS .