Resetting Service Reminder Indicator (SRI) after a service without using VAG1551/1552 ST
The service message must be reset after a service has been performed.
Re-setting the Service Reminder Indicator (SRI) can be performed with the VAG1551 Scantool in the "adaptation" function. See ADAPTATION .
The SRI can also be reset via the following procedure:
- Switch off ignition.
- Press reset button for trip recorder in instrument cluster and switch on ignition at the same time.
The following appears in display after releasing trip recorder: "SERVICE IN ????MI" or "SERVICE!".
- Turn adjustment button for clock in instrument cluster to left within 5 seconds until the message is reset to "SERVICE IN ????MI" or "SERVICE!"
The display reads: "SERVICE IN 8000 MI".
- Switch off ignition.
NOTE:
- Channels 40, 41, 46, 47 and 48 which display the dynamic value of the service event are set to "0" automatically.
- For re-setting without VAG1551/1552, adaptation channels are set to the values shown in SRI ADAPTATION CHANNEL SETTING VALUES table.
SRI ADAPTATION CHANNEL SETTING VALUES
| Channel 42 (minimum mileage performance) | 8000 mi |
| Channel 43 (maximum mileage performance) | 8000 mi |
| Channel 44 (maximum time interval until next service) | 365 days |
| Channel 45 (oil quality) | 1 |