Clutch Pressure Plate &/Or Disc: Remove & Replace
WARNING: This page is about the A4 Quattro, 1.8 B, which is a different variant/trim than selected.
Includes: R&I Engine or Transaxle Assembly (where applicable).
DOES NOT include resurface Flywheel.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| AWD | 8.0 | C | ||
| Combination Procedure: CLUTCH PILOT BEARING: Remove & Replace: | ||||
| 0.7 | C | |||
| Combination Procedure: CLUTCH RELEASE BEARING: Remove & Replace: | ||||
| 0.2 | C | |||
| Combination Procedure: CRANKSHAFT MAIN OIL SEAL: Remove & Replace: | ||||
| In-Line4, Rear | Includes: R&I Oil Pan. | 2.6 | B | |
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| 0.3 | C | |||
| Combination Procedure: FLYWHEEL (REMOVED): Resurface: | ||||
| 0.8 | B | |||