Initiate coding

Indicated on display:

Fig 1: Scan Tool Display - Control Module Coding, Automatic Headlight Beam Adjusting (1 Of 6)

Courtesy of AUDI OF AMERICA, INC.

• Press buttons 0 and 7. With 07 the function "Code control module" is selected.
• Press Q button to confirm input.

  Indicated on display:

  Fig 2: Scan Tool Display - Control Module Coding, Automatic Headlight Beam Adjusting (2 Of 6)

  Courtesy of AUDI OF AMERICA, INC.
• Enter code number from code table, see CODE .

  Example: 00008

  Indicated on display:

  Fig 3: Scan Tool Display - Control Module Coding, Automatic Headlight Beam Adjusting (3 Of 6)

  Courtesy of AUDI OF AMERICA, INC.
• Press Q button to confirm input.

  After approx. 5 seconds the following appears on the display:

  Fig 4: Scan Tool Display - Control Module Coding, Automatic Headlight Beam Adjusting (4 Of 6)

  Courtesy of AUDI OF AMERICA, INC.
• Press --> button to end coding.

  Indicated on display:

  Fig 5: Scan Tool Display - Control Module Coding, Automatic Headlight Beam Adjusting (5 Of 6)

  Courtesy of AUDI OF AMERICA, INC.
• Press buttons 0 and 6. With 06 the function "End output" is selected.

  Indicated on display:

  Fig 6: Scan Tool Display - Control Module Coding, Automatic Headlight Beam Adjusting (6 Of 6)

  Courtesy of AUDI OF AMERICA, INC.
• Press Q button to confirm input.