Perform Output Diagnostic Test Mode:

Indicated on display:

Fig 1: Scan Tool Display- Output Diagnostic Test Mode, Automatic Headlight Beam Adjusting

Courtesy of AUDI OF AMERICA, INC.

DTM for headlight beam adjusting is started.

Indicated on display:

Fig 2: Scan Tool Display - Output Diagnostic Test Mode, Lower Head Lights

Courtesy of AUDI OF AMERICA, INC.

The headlights were lowered to the point when program was advanced or until the stop position was reached.

Indicated on display:

Fig 3: Scan Tool Display - Output Diagnostic Test Mode, Raise Headlights

Courtesy of AUDI OF AMERICA, INC.

The headlights were raised to the point when program was advanced or until the stop position was reached.

Indicated on display:

Fig 4: Scan Tool Display - Output Diagnostic Test Mode, End

Courtesy of AUDI OF AMERICA, INC.

1551 Scan Tool (ST) is again in the basic function.

Indicated on display:

Fig 5: Scan Tool Display - Select Function XX

Courtesy of AUDI OF AMERICA, INC.