Perform Output Diagnostic Test Mode:

Press buttons 0 and 4. With 04 the function "Basic setting" is selected.
Indicated on display:

Fig 1: Scan Tool Display - Basic Setting, Automatic Headlight Beam Adjusting
Courtesy of AUDI OF AMERICA, INC.
Press Q button to confirm input.
Indicated on display:

Fig 2: Scan Tool Display - Basic Setting, Input Display Group Number
Courtesy of AUDI OF AMERICA, INC.
Enter display number 001.
Press Q button to confirm input.
Indicated on display:

Fig 3: Scan Tool Display - Basic Setting, Display Number 1
Courtesy of AUDI OF AMERICA, INC.
Headlights move into adjustment position.
Indicated on display:

Fig 4: Scan Tool Display - Basic Setting, Adjust Headlights
Courtesy of AUDI OF AMERICA, INC.
The headlights are now in the adjustment position. Adjust headlights with VAS5107 headlight tester. Basic setting 1 switches the adjustment off and the message "Headlights not adjusted" will be placed in memory.
Press --> button.
Indicated on display:

Fig 5: Scan Tool Display - Select Function XX
Courtesy of AUDI OF AMERICA, INC.
Press buttons 0 and 4. With 04 the function "Basic setting" is selected.
Indicated on display:

Fig 6: Scan Tool Display - 04 Basic Setting
Courtesy of AUDI OF AMERICA, INC.
Press Q button to confirm input.
Indicated on display:

Fig 7: Scan Tool Display - Input Display Group Number XXX
Courtesy of AUDI OF AMERICA, INC.
Enter display group number 002.
Press Q button to confirm input.
Indicated on display:

Fig 8: Scan Tool Display - System In Basic Setting, Adjustment Position Learned
Courtesy of AUDI OF AMERICA, INC.
The control module has now learned the adjustment position. Message "Headlight not adjusted" will be erased from memory and the normal adjusting mode is again activated.
Press --> button.
Indicated on display:

Fig 9: Scan Tool Display - Select Function XX
Courtesy of AUDI OF AMERICA, INC.