LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 1999 >> A6 Quattro >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Suspension - Rear, AWD) >> Removal & Installation >> Lower Control Arm >> Removal

Lower Control Arm: Removal

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle. Remove wheel. Remove ABS sensor wiring and clips from lower control arm. See Fig 1 . Remove parking brake cable bracket. Remove lower control arm-to-subframe bolts.
    Fig 1: Locating ABS Sensor Wiring & Parking Brake Cable
    G00352277Courtesy of AUDI OF AMERICA, INC.
  2. On vehicles equipped with headlight vertical aim control, disconnect harness connector from level control. See Figure .
  3. Remove parking brake cable from lower control arm. See Fig 2 . Remove strut assembly-to-lower control arm bolt. Mark position of lower control arm-to-wheel bearing housing eccentric bolt. Remove eccentric bolt. Remove lower control arm.
    Fig 2: Removing Parking Brake Cable & Lower Control Arm
    G00352278Courtesy of AUDI OF AMERICA, INC.