Ignition/starter switch, removing and installing: Removing

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Remove steering column switch:
See REMOVING STEERING COLUMN SWITCH .
Disconnect electrical connection for induction coil -4-.
Disconnect electrical connection -1- at ignition/starter switch -2-.
Remove sealing paint from both mounting screws -A-.
Loosen mounting bolts -A- somewhat and pull ignition/starter switch -2- out of steering lock housing -3- in direction of arrow.

Fig 1: Pulling Ignition/Starter Switch Out Of Steering Lock Housing

Courtesy of AUDI OF AMERICA, INC.