Rear lid trim, removing and installing

The following list pertains to Fig 1.

1. Rear lid trim 
2. Remove hazard warning triangle.
   • Remove screws -4- (2x).
   • Remove bracket for hazard warning triangle -5-.
   • Remove screws -2- (2x).
   • Remove screws -3- (2x).
   • Unclip trunk lid trim -1- from underneath.
3. Screws (2x) 
   • Tightening torque: 1.5 Nm (13 in lb)
4. Screws (2x) 
   • Tightening torque: 1.5 Nm (13 in lb)
5. Screws (2x) 
   • Tightening torque: 1.5 Nm (13 in lb)
6. Bracket for hazard warning triangle 
Fig 1: Removing And Installing Rear Lid Trim (Sedan)
Courtesy of AUDI OF AMERICA, INC.