Cargo area floor trim and supports (Avant), removing and installing
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
The following list pertains to Fig 1.
- Cargo area floor covering (front)
- Remove screws -2- (4x) for fastening rings -3-.
- Screws (2x)
- Tightening torque: 4.5 Nm (40 in lb)
- Fastening rings
- Support for cargo area floor covering (front wheel drive models)
- Remove front floor covering -1-.
- Pull out rear floor covering -7- toward the rear.
- Remove cargo area side trim on one side. See CARGO AREA SIDE TRIM .
- Remove support -4- for floor covering.
- Support for cargo area floor covering (quattro models)
- Pull out rear floor covering -7- toward the rear.
- Detach the two side floor coverings -8- and -6- (left and right).
Supports -5- for floor covering are secured with butyl cord.
- Remove supports -5- for floor covering.
- Cargo area floor covering (side)
- Secured with adhesive tape
- Cargo area floor covering (rear)
- Pull out toward the rear.
- Cargo area floor covering (side)
- Secured with adhesive tape