Removal & Installation: Notes

CAUTION: Do not use power tools to tighten fasteners, torque specifications could be exceeded. Due to extensive use of aluminum components, use only special coated bolts to prevent corrosion. Always use NEW axle bolt, driveshaft bolts, lower shock absorber bolts, subframe bolts, and all self-locking nuts.

NOTE: Bonded rubber bushings can only be turned to a limited extent. Bolted connections should only be torqued to specification once vehicle is resting on its own weight. Otherwise, rubber bushing will be stressed and have a shortened service life.

NOTE: When drive axle is removed, vehicle must not be moved. Moving vehicle without driveshaft will damage wheel bearing. If vehicle must be moved, temporarily install outer constant velocity joint in place of drive axle.