LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 1998 >> A8 Quattro >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Servicing - A/T (01V, Fwd)) >> Lubrication >> Draining & Refilling >> 01V Transaxle (Changing Or Topping Off After Repair Work)

01V Transaxle (Changing Or Topping Off After Repair Work)

WARNING: This page is about a different variant/trim than selected.
    CAUTION: Engine must not be started without ATF and vehicle must not be towed!
  1. Place drain pan under transaxle. Remove drain plug (1). See Figure . Drain ATF.
  2. Install NEW drain plug and oil seal. Tighten to 30 ft. lbs. (40 N.m).
  3. Connect ATF reservoir from filling system (V.A.G. 1924) to vehicle. Raise and support vehicle.
  4. Remove ATF inspection plug (2). See Figure . Using ATF Filling System (V.A.G. 1924), carefully insert fill hose through an opening in deflector cap (4). See Figure and Figure . Ensure deflector cap is not pushed upward out of position.
  5. Fill until ATF runs out of inspection hole.
  6. Shift selector lever into "P" position. Start engine.
  7. Press and hold brake pedal. Shift through all selector lever positions with vehicle stationary, leaving selector lever in each position for approximately 10 seconds, and ending in "P" position.
  8. Check fluid level and top off. See CHECKING FLUID LEVELS  . Add ATF as necessary. Replace seal on ATF inspection plug. Tighten inspection plug to 59 ft. lbs. (80 N.m).
scientia non olet · About LEMON Manuals