Rear seat heater switch, removing and installing: Removing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2003 Audi S8, 2003 Audi A8, 2002 Audi S8, 2002 Audi A8, and 2001 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the trim -A- carefully. See Fig 1.
- Remove both Phillips-head screws -B- and remove the air outlet.
- Push the individual switch from the frame from behind by hand.
- Then pull out the switch and disconnect the harness connector.