Automatic vertical aim control system control module -J431-, removing and installing: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2003 Audi S8, 2003 Audi A8, 2002 Audi S8, 2002 Audi A8, and 2001 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

Remove right B-pillar trim.
See B-PILLAR TRIM, REMOVING AND INSTALLING .
The automatic vertical aim control system control module -1- is installed behind the right B-pillar trim.
Disconnect connector.
Remove both hex nuts (size in mm: 10) -2- to remove the automatic vertical aim control system control module -1-.

Fig 1: Removing Hex Nuts & Automatic Vertical Aim Control System Control Module

Courtesy of AUDI OF AMERICA, INC.