Work sequence

WARNING: This page is about a different car, the 2003 Audi RS 6. However, it is still accessible from the selected car via links, so may be relevant.

Connect vehicle diagnostic, testing and information system VAS 5051. See VEHICLE DIAGNOSTIC, TESTING AND INFORMATION SYSTEM VAS 5051, CONNECTING AND SELECTING FUNCTIONS and select vehicle system "01 - Engine electronics" from list. Ignition must be on.

Or, depending on desired operation:

Start engine.

Indicated on VAS 5051:

Fig 1: Function Display VAS 5051 - Basic Setting (1 Of 2)

Courtesy of AUDI OF AMERICA, INC.

From list -1- select diagnostic function "04 - Basic setting".

Indicated on VAS 5051:

Fig 2: Function Display VAS 5051 - Basic Setting (2 Of 2)

Courtesy of AUDI OF AMERICA, INC.

- Enter display group

Use keypad -2- to enter required three -digit display group number and confirm entry by touching Q key.

Example:

Enter "001" for "Display group number 001" and confirm by touching Q key.

Indicated on VAS 5051:

Fig 3: Function Display VAS 5051 - Basic Setting, Example (1 Of 2)

Courtesy of AUDI OF AMERICA, INC.

- Measured values not in basic setting
- Measured values in basic setting
- Display group X

- Activate basic setting

NOTE: Basic setting is initiated after touching key -A-.

Fig 4: Function Display VAS 5051 - Basic Setting, Example (2 Of 2)

Courtesy of AUDI OF AMERICA, INC.

Indicated on VAS 5051:

- Display zone 1
- Display zone 2
- Display zone 3
- Display zone 4

End function "04 - Basic setting" by touching > key.