Driver's storage compartment, removing
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
The following list pertains to Fig 1 .
- Driver's storage compartment
- Remove instrument cluster molding. See INSTRUMENT CLUSTER MOLDING, REMOVING .
- Unclip end trim of instrument panel on driver's side. See REMOVING INSTRUMENT PANEL END TRIM (LEFT) .
- Remove bolts -2- (5x).
- Set down driver's storage compartment.
- Disconnect connector -3- from footwell light -4-.
- Unclip Data Link Connector (DLC) -6- by squeezing together the tabs -5- (3x).
- Bolts (5x)
- Connector
- Footwell light
- Tabs
- Data Link Connector (DLC)