LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 1997 >> Cabriolet >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Fuel Supply, Generic Scan Tool - 4.2L V8 - Art, Awn, BBD) >> Fuel Supply >> Fuel supply system >> Fuel Pump (FP) and Sender for fuel gauge - component overview >> Fuel pump, removing and installing >> Final procedures

Final procedures

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2004 Audi A6, 2003 Audi S6, 2003 Audi A6, 2002 Audi S6, and 2002 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.

After re-connecting the voltage supply, the following work steps must be performed in the mentioned sequence:

  1. - Check DTC memory. See MODE 3: CHECK DTC MEMORY .
  2. - If necessary, erase DTC memory. See MODE 4: RESET/ERASE DIAGNOSTIC DATA .
  3. - Generate readiness code. See READINESS CODE, GENERATING .
scientia non olet · About LEMON Manuals