Ignition/starter switch, removing and installing: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2003 Audi S8, 2003 Audi A8, 2002 Audi S8, 2002 Audi A8, and 2001 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

Steering column switch, removing. See Steering column switches, removing and installing .
Disconnect harness connector at ignition/starter switch.
Remove sealing paint from two retaining screws -A-. See Fig 1.
Slightly loosen retaining screws -A- and pull ignition/starter switch out of steering lock housing in direction of arrow.

Fig 1: Pulling Ignition/Starter Switch Out Of Steering Lock Housing

Courtesy of AUDI OF AMERICA, INC.