Left front level control system sensor -G78-, removing and installing: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2003 Audi S8, 2003 Audi A8, 2002 Audi S8, 2002 Audi A8, and 2001 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

The front level control system sensor -1- is bolted to a retaining plate on the long member with two socket head bolts -5- (5mm).
Disconnect connector.
To remove sensor from retaining plate and linkage, remove hex nut -3- and both socket head bolts -2- (3mm) at level sensor.

Fig 1: Removing Left Front Level Control System Sensor From Retaining Plate And Linkage

Courtesy of AUDI OF AMERICA, INC.

Open clip -1- at control arm by lightly pressing together the catches. Then remove linkage -2-.

Fig 2: Opening Clip & Removing Linkage

Courtesy of AUDI OF AMERICA, INC.