On Board Diagnostic (OBD), function

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2003 Audi S8, 2003 Audi A8, 2002 Audi S8, 2002 Audi A8, and 2001 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

The instrument cluster is controlled by an internal microprocessor with On Board Diagnostic (OBD) capability. If malfunctions occur in monitored sensors and components, Diagnostic Trouble Codes (DTC) will be stored in memory.

If OBD recognizes instrument cluster malfunctions related to the:

odometer
speedometer calibration

The trip odometer display will change to show "dEF.".

In this case, replace speedometer. See INSTRUMENT CLUSTER, REMOVING AND INSTALLING .

Other malfunctions recognized by OBD will not cause the trip odometer display to change as described above.

Before performing any troubleshooting or inspection, always begin by checking for DTCs using the On Board Diagnostic (OBD) program. DTCs stored in memory are retrieved/checked with VAS 5051 in mode "Self Diagnosis"

Where applicable, also use VAS 5051 tester in mode "Guided Fault Finding".