Diagnostic Trouble Code (DTC) Memory, checking (function 02)

NOTE: The displayed DTC information is updated only when initiating OBD or with "Erase DTC Memory" function 05.

Switch printer on via the PRINT button (indicator lamp in button lights up).

Indicated on display

Fig 1: Identifying Scan Tool Display - Checking DTC Memory (Navigation System IV) (1 Of 5)

G02728566

Courtesy of AUDI OF AMERICA, INC.

Press buttons -0- and -2- to select "Check DTC memory", function 02.

Indicated on display

Fig 2: Identifying Scan Tool Display - Checking DTC Memory (Navigation System IV) (2 Of 5)

G02728567

Courtesy of AUDI OF AMERICA, INC.

Press -Q- button to confirm input.

The number of stored malfunctions appears in the display.

Fig 3: Identifying Scan Tool Display - Checking DTC Memory (Navigation System IV) (3 Of 5)

G02728568

Courtesy of AUDI OF AMERICA, INC.

The stored malfunctions are displayed and printed out one after the other.

Check print-out against DTC table and repair all malfunctions as necessary. See DIAGNOSTIC TROUBLE CODE (DTC) TABLE .

If "No DTC recognized!" is displayed, the program will return to "Select function XX" after the --> button is pressed.

Fig 4: Identifying Scan Tool Display - Checking DTC Memory (Navigation System IV) (4 Of 5)

G02728569

Courtesy of AUDI OF AMERICA, INC.

Indicated on display

Fig 5: Identifying Scan Tool Display - Checking DTC Memory (Navigation System IV) (5 Of 5)

G02728570

Courtesy of AUDI OF AMERICA, INC.

If something else is displayed:

See Operating instructions of Scan Tool (ST)

End Output (function 06). See END OUTPUT (FUNCTION 06) .
Switch off ignition and disconnect diagnostic wire from Data Link Connector (DLC).