Automatic test sequence

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 Audi S8, 2003 Audi A8, 2002 Audi S8, 2002 Audi A8, and 2001 Audi A8. However, it is still accessible from the selected car via links, so may be relevant.

Press button -0- twice to select address word "Automatic test sequence" and confirm entry with -Q- button. VAG1551 scan tool transmits all known address words in sequence.
When a control module answers with its identification, the number of stored malfunctions appears or "No DTC recognized" is displayed.

Any system malfunctions that are stored will be displayed one after the other and printed out. The VAG1551 scan tool will then transmit the next address word.

The automatic test sequence has ended when the following appears on the display:

Fig 1: VAG1551 Scan Tool Display - Automatic Test Sequence (1 Of 2)

Courtesy of AUDI OF AMERICA, INC.

Erase all DTC memories and then perform a road test.
Check DTC memories of all control modules again using "Automatic test sequence." No malfunctions should be stored in DTC memory.

If no malfunction is stored:

Press --> button.

Indicated on display:

Fig 2: VAG1551 Scan Tool Display - Automatic Test Sequence (2 Of 2)

Courtesy of AUDI OF AMERICA, INC.

Press buttons -0- and -6- to select "End Output" function and confirm input with -Q- button.