LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 1994 >> Cabriolet >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Testing >> Rpm Sensor Test

Rpm Sensor Test

  1. Turn ignition off. Remove instrument cluster. Disconnect Green instrument cluster 26-pin wiring harness connector. Inspect connector pin terminals for damage and repair as necessary.
  2. Connect Green 26-pin connector to Circuit Tester (VAG 1598). Connect Green test lead of Tester (VW 1367) to terminal No. 12 of Green 26-pin connector. See Figure . Start engine. Engine speed should be indicated on tester. If engine speed is not indicated, repair open circuit in wiring harness.
scientia non olet · About LEMON Manuals