Warning Indicators

Warning display lights come "ON" when systems are not properly functioning. The following list are reasons why display would indicate system troubles:

• When brake fluid level display light comes on, brake fluid level is too low, or operating pressure of power brake is below 1740 psi (122 kg/cm² ).
• When engine oil display light appears, engine oil pressure is below 26 psi (1.8 kg/cm² ) at 2000 RPM, or oil pressure is below 4 psi (.28 kg/cm² ).
• When water temperature display light appears, coolant temperature is above 248°F (120°C).
• When stop light display appears, brake light is not operating because of bulb, fuse, switch or wiring.
• When brake pad warning light is displayed, pad thickness without backing plates are approximately .080" (2.0 mm).
• When headlamp low beam is displayed, headlamp low beam, or tail light is not operating because of bulb, fuse, switch or wiring.
• When battery is displayed, battery voltage is below 10.6 volts or above 15.6 volts.
• When windshield washer is displayed, fluid level of washer reservoir is too low to use.
• When gasoline is displayed, remaining fuel in tank is approximately 3 gallons (12 L).
• When OK is displayed, there is no system failure.