LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 1982 >> 4000 Base, 2D Sedan >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 4000 4-Cylinder >> Engine & Cylinder Head >> Cylinder Head >> Installation

Cylinder Head: Installation

  1. Clean all gasket mating surfaces. Install cylinder head gasket DRY, using no sealant. Install cylinder head and manifolds. Install head bolts 8 and 10 to align cylinder head, then install remaining head bolts. See Fig 1.
  2. Tighten head bolts in 3 steps, turning bolts an additional 1/4 turn after final tightening. See Fig 1. Install remaining components in reverse order of removal. Ensure valve timing is correct. Adjust timing belt tension and adjust valves.
    Fig 1: Cylinder Head Tightening Sequence
    G09331919Courtesy of AUDI OF AMERICA, LLC

    Install bolts 8 and 10 to align cylinder head, then install remaining bolts. 

scientia non olet · About LEMON Manuals