LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 1982 >> 4000 Base, 2D Sedan >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 4000 4-Cylinder >> Crankshaft Main & Connecting Rod Bearings >> Front Main Bearing Oil Seal >> Removal

Front Main Bearing Oil Seal: Removal

  1. Remove all drive belts. Remove upper timing belt cover. Set No. 1 piston on TDC after compression stroke. Remove crankshaft pulley. Loosen crankshaft sprocket bolt. Remove water pump pulley.
  2. Remove lower timing belt cover. Relieve tension on timing belt. Remove crankshaft sprocket with timing belt attached. Do not allow sprocket and timing belt to separate. Using seal removing tool (10-221), carefully pry oil seal from flanged cover.
scientia non olet · About LEMON Manuals