Clutch Pressure Plate &/Or Disc: Remove & Replace

WARNING: This page is about the 100 2D Sedan, 1.8L Eng, Automatic Trans, which is a different variant/trim than selected.

Includes: R&I Engine or Transaxle Assembly (where applicable). DOES NOT include resurface Flywheel.

Applies To	Standard Hours	Skill Level
	7.7	C
Combination Procedure: CLUTCH PILOT BEARING: Remove & Replace:
	0.1	C
Combination Procedure: CLUTCH RELEASE BEARING: Remove & Replace:
	0.2	C
Combination Procedure: CRANKSHAFT MAIN OIL SEAL: Remove & Replace:
Rear	0.4	B
Combination Procedure: FLYWHEEL: Remove & Replace:
	0.3	C
Combination Procedure: FLYWHEEL (REMOVED): Resurface:
	0.8	B