Brake Pads: Remove & Replace
WARNING: This page is about the Tonale Base, 1.3L Eng VIN W, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All,Both Axles | 1.8 | B | ||
| Front,Both Sides | 1.0 | B | ||
| Rear,Both Sides | 1.0 | B | ||
| Combination Procedure: 12 VOLT BATTERY SHUTOFF PROCEDURE: Perform: | ||||
| Rear Axle | 0.5 | C | ||
| Combination Procedure: BRAKE HOSE: Replace: | ||||
| Each Additional | DOES NOT include Bleed System. | 0.2 | B | |
| One | DOES NOT include Bleed System. | 0.3 | B | |
| Combination Procedure: BRAKE SYSTEM: Bleed: | ||||
| 0.6 | B | |||
| Combination Procedure: CALIPER: Overhaul: | ||||
| Serviced as an Assembly. | B | |||
| Combination Procedure: CALIPER: Replace: | ||||
| One | DOES NOT include Bleed System. | 0.1 | B | |
| Combination Procedure: ELECTRONIC PARKING BRAKE SYSTEM: Disable & Enable: | ||||
| Maintenance Mode | 0.2 | B | ||